On Sat, 30 Jan 2010 12:53:29 +0100 Didier Corbière marsender@free.fr wrote:

Sorry, here is the thread again, but in plain text,

I think most of users don't care about the multipart message ;)

I would like to run a project command with the full filename, including it's path. I only find this variables available to run commands:

* %f -- complete filename without path
* %e -- filename without path and without extension

Could you tell me which variable can be used for a full filename, including it's path ?

Which version of Geany are you using? Inside current svn version it should be possible by combining %d and %f in a good way. But this has been introduced after 0.18 so not yet available inside a stable release.

If you are running 0.18 or below I'd suggest to use a make file and set up a special target for your action so you could call it by make some_fancy_action or by using the make custom target menu item.

Hope this helps, Frank