On 5 January 2015 at 02:06, Simon Langley simon@ouryard.net wrote:

I want to make Geany use my preferred build commands. I can do it with a new project by using Build/Set build commands but then have to do it again for each project. Reading the manual I thought that all I needed to do was make a copy of the filetypes file and modify it. So, I copied /usr/share/geany/filetypes.cpp to .config/geany/filedef/filetypes.cpp and modified [build_settings] and [build_menu]

[build_settings] # %f will be replaced by the complete filename # %e will be replaced by the filename without extension # (use only one of it at one time) # compiler=builder compile source=%f #linker=g++ -Wall -o "%e" "%f" #run_cmd="./%e"

[build_menu]

Its build-menu not build_menu

Cheers Lex

FT_00_LB=_compile FT_00_CM=b compile source=%f FT_00_BD=

NF_01_LB=_build NF_01_CM=b build NF_01_BD=

NF_02_LB=_clean NF_02_CM=b clean NF_02_BD=

NF_03_LB=_rebuild NF_03_CM=b rebuild NF_03_BD=

I created a new geany project, tried adding/creating .cpp but the build commands remain at their default settings. What am I doing wrong?

Thanks,

Simon Langley

---

Users mailing list Users@lists.geany.org https://lists.geany.org/cgi-bin/mailman/listinfo/users