[Geany-Users] Configuring build commands

[Lex Trotman]

On 5 January 2015 at 02:06, Simon Langley <simon at ouryard.net> wrote:
> I want to make Geany use my preferred build commands.  I can do it with a
> new project by using Build/Set build commands but then have to do it again
> for each project.  Reading the manual I thought that all I needed to do was
> make a copy of the filetypes file and modify it.  So, I copied
> /usr/share/geany/filetypes.cpp to .config/geany/filedef/filetypes.cpp  and
> modified [build_settings] and [build_menu]
>
> [build_settings]
> # %f will be replaced by the complete filename
> # %e will be replaced by the filename without extension
> # (use only one of it at one time)
> # compiler=builder compile source=%f
> #linker=g++ -Wall -o "%e" "%f"
> #run_cmd="./%e"
>
> [build_menu]

Its build-menu not build_menu

Cheers
Lex


> FT_00_LB=_compile
> FT_00_CM=b compile source=%f
> FT_00_BD=
>
> NF_01_LB=_build
> NF_01_CM=b build
> NF_01_BD=
>
> NF_02_LB=_clean
> NF_02_CM=b clean
> NF_02_BD=
>
> NF_03_LB=_rebuild
> NF_03_CM=b rebuild
> NF_03_BD=
>
> I created a new geany project, tried adding/creating  .cpp but the build
> commands remain at their default settings.     What am I doing wrong?
>
> Thanks,
>
> Simon Langley
>
>
>
> _______________________________________________
> Users mailing list
> Users at lists.geany.org
> https://lists.geany.org/cgi-bin/mailman/listinfo/users